Disconnect all speaker connections and rca cables. Leave power, ground and remote wires intact. Try turning on again. If you still have a protection light your amp is faulty. Hopefully you have warranty. Good L .A thumbs up would be greatly appreciated if this answer is helpful to you. MTX Audio
There's no troubleshooting information in the install sheet and I could not find anything on Mitek's support page either.
I'd recommend that you fill out the support form here, or call them toll-free at (800) 225-5689. But good luck! My experience with MTX and their technical support is that they fall woefully short of adequate. Just like their documentation and the general quality of most MTX products. It's just not on the same level that you get from JL Audio, Rockford-Fosgate, Infinity, Alpine, and many others.
Answers & Comments
Disconnect all speaker connections and rca cables. Leave power, ground and remote wires intact. Try turning on again. If you still have a protection light your amp is faulty. Hopefully you have warranty. Good L .A thumbs up would be greatly appreciated if this answer is helpful to you. MTX Audio
Hello hondarid3r58,
There's no troubleshooting information in the install sheet and I could not find anything on Mitek's support page either.
I'd recommend that you fill out the support form here, or call them toll-free at (800) 225-5689. But good luck! My experience with MTX and their technical support is that they fall woefully short of adequate. Just like their documentation and the general quality of most MTX products. It's just not on the same level that you get from JL Audio, Rockford-Fosgate, Infinity, Alpine, and many others.
Hope this helps.