My GWL15 has similar symptoms. It would stop at rinse cycle and sound a three tone alarm. I also noticed a leak. I could restart it but it usually would fail again. When I advance to spin cycle, it did not spin normally.

I ran through the diagnostics and got error #37. Other than that, the pump, diverter, and motor controller seemed normal. Once I flipped it over, I noticed rust and leakage indications on the water pump.

I ordered the pump $90, diverter valve $35, and master control board $110 from Fisher & Paykel parts. I replaced the pump and everything is working normally.

Sending back the other (unopened) parts for full refund today.

I hope this helps someone with similar problems.

Clogged pump stopped up drain. If the washer does not think all water was pumped out in 8 minutes then it shuts down. Slow drain is my first inclination.


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61