If the freezer is working but fridge is not working then check this as follows:-- Check if the fan inside the freezer works. It should be "on' at the same time when the compressor is running.
Check if there is frost on the back panel in the freezer. If there is Frost on the rear wall, the defrost system has failed. Their is a heater and bi-metal (located behind the rear freezer wall in the evaporator), and a timer (usually near the controls). Try this unplug the unit from main power outlet.keep both the doors open for nearly 24 hours minimum.This will defrost all the ice collected or stuck up in between the evaporator coils.Then reconnect power to the unit and check.If still the problem then there is a failure in defrost system if the compressor is checked OK.Other wise its weak compressor problem if defrost system checks out OK. Thanks. keep updated for any more query.you can rate this solution and show your appreciation.
Inspect the gasket for dirt or debris that could prevent it from sealing. If you find any, remove the large debris, then wash the gasket, using a scrub brush and warm, soapy water. Check the gasket for cracks or tears that can let cold air escape. If you find any, replace the gasket. Check the seal: Open the door, insert a dollar bill partway and shut the door on the bill. Try to pull out the bill. You should feel some resistance. Repeat the test at several points around each door. If the bill slips out easily, replace the gasket.
If there is any circuit breaker, reset it.
Check for thermostat problems. It could be off or won't cool properly (too warm,). If it can't be fixed with a simple adjustment, call a professional.
Check for coil problems. The compressor can overheat due to dust buildup on condenser coils. If so, vacuum the coils.
The above are the likely problem and the solution.
The defrost timer is usually found behind the front grill "toe kick" of the refrigerator. It may also be found behind a cover plate inside the refrigerator or freezer, in the temperature control console, or behind the refrigerator near the compressor.
To test whether the defrost timer is simply failing to advance, locate the advance screw and turn it clockwise until you hear it click. This advances it to the next mode. If it was cooling before, it is now in defrost mode. Simply wait about 35 minutes and check whether it has left defrost mode and has resumed cooling (listen for the compressor). If it does not advance, the timer motor is probably bad and the entire timer needs to be replaced. If it advances as it should, then you can follow the steps below to test the switch electrically.
The timer is usually held in place with one or more screws. Remove the screws and gently pull the timer out far enough to disconnect the wiring connector. The connector can be removed by firmly pulling and rocking it left and right. It is not necessary to note the position of the wires because the connector plug is keyed so that it can be replaced in only one way.
Take care.
Hello,
The defrost timer is usually found behind the front grill "toe kick" of the refrigerator. It may also be found behind a cover plate inside the refrigerator or freezer, in the temperature control console, or behind the refrigerator near the compressor. To test whether the defrost timer is simply failing to advance, locate the advance screw and turn it clockwise until you hear it click. This advances it to the next mode. If it was cooling before, it is now in defrost mode. Simply wait about 35 minutes and check whether it has left defrost mode and has resumed cooling (listen for the compressor). If it does not advance, the timer motor is probably bad and the entire timer needs to be replaced. If it advances as it should, then you can follow the steps below to test the switch electrically. The timer is usually held in place with one or more screws. Remove the screws and gently pull the timer out far enough to disconnect the wiring connector. The connector can be removed by firmly pulling and rocking it left and right. It is not necessary to note the position of the wires because the connector plug is keyed so that it can be replaced in only one way.
There are many people that have this problem and are searching for answers as to what to do and what could be causing this problem. It seems to be weird that the freezer is working fine and the fridge side is not. Why would the coldest side be good and the warmer side not?
The answer to these questions lies in the way the freezer/fridge combo works. The freezer is where the cooling coils are located. Then air is moved over the coils and circulated through the fridge side by a small blower or fan. The problem arises when the air is not circulated for some reason.
The reasons the air is not moving is usually two reasons
The fan or blower has failed.
The coil is covered over with ice and blocks the air flow.
The first reason is pretty simple to fix, you simply replace the air circulator and things are good again. The second reason can be more difficult. 1.The timing device that runs the defrost cycle of the refrigerator is defective. 2.The heater coil that melts the water is shorted or not working
Usually the first thing to check is the heater coil. If there is resistance through the coil then most likely it is still good. The timing device can be an advanced defrost control board or a mechanical timing device. If the heater coil checks out to be good then the problem should be the timer.
For most situations, unplugging the refrigerator and allowing it to defrost on it’s own will get you going temporarily, till parts can be shipped to you. That will melt the ice and give you a few days or a couple of weeks till it ices up to the point where it will not work again.
So you can see here, the problem can usually be traced to one of three things.
The fan or blower
The timer device
The electric heater coil
By methodically checking these parts you can isolate your problem and fix it.
yes, it means the fan is working from the fan sound you are hearing. The questions you asked has put more light to the problem.
Inspect the gasket for dirt or debris that could prevent it from sealing. If you find any, remove the large debris, then wash the gasket, using a scrub brush and warm, soapy water.
Check the gasket for cracks or tears that can let cold air escape. If you find any, replace the gasket. If the gasket appears to be solid, go on to step 3. Check the seal: Open the door, insert a dollar bill partway and shut the door on the bill. Try to pull out the bill. You should feel some resistance. Repeat the test at several points around each door. If the bill slips out easily, replace the gasket.
If there is any circuit breaker, reset it.
Check for thermostat problems. It could be off or won't cool properly (too warm,). If it can't be fixed with a simple adjustment, call a professional.
Check for coil problems. The compressor can overheat due to dust buildup on condenser coils. If so, vacuum the coils.
The above are the likely problem and the solution.
There is no schematic, if not, I would have given it to you. But you can check the below link, its one of our refrigerator expert's profile and I believe the information there could help to solve your problem as there are some diagrams there.
http://www.fixya.com/support/r4024657-re...
Take care
Hello,
yes, it means the fan is working from the fan sound you are hearing. The questions you asked has put more light to the problem.
Inspect the gasket for dirt or debris that could prevent it from sealing. If you find any, remove the large debris, then wash the gasket, using a scrub brush and warm, soapy water.
Check the gasket for cracks or tears that can let cold air escape. If you find any, replace the gasket. If the gasket appears to be solid, go on to step 3. Check the seal: Open the door, insert a dollar bill partway and shut the door on the bill. Try to pull out the bill. You should feel some resistance. Repeat the test at several points around each door. If the bill slips out easily, replace the gasket.
If there is any circuit breaker, reset it.
Check for thermostat problems. It could be off or won't cool properly (too warm,). If it can't be fixed with a simple adjustment, call a professional.
Check for coil problems. The compressor can overheat due to dust buildup on condenser coils. If so, vacuum the coils.
The above are the likely problem and the solution.
There is no schematic, if not, I would have given it to you. But you can check the below link, its one of our refrigerator expert's profile and I believe the information there could help to solve your problem as there are some diagrams there.
Answers & Comments
If the freezer is working but fridge is not working then check this as follows:--
Check if the fan inside the freezer works. It should be "on' at the same time when the compressor is running.
Check if there is frost on the back panel in the freezer.
If there is Frost on the rear wall, the defrost system has failed. Their is a heater and bi-metal (located behind the rear freezer wall in the evaporator), and a timer (usually near the controls).
Try this unplug the unit from main power outlet.keep both the doors open for nearly 24 hours minimum.This will defrost all the ice collected or stuck up in between the evaporator coils.Then reconnect power to the unit and check.If still the problem then there is a failure in defrost system if the compressor is checked OK.Other wise its weak compressor problem if defrost system checks out OK.
Thanks. keep updated for any more query.you can rate this solution and show your appreciation.
Hello,
Inspect the gasket for dirt or debris that could prevent it from sealing. If you find any, remove the large debris, then wash the gasket, using a scrub brush and warm, soapy water.
Check the gasket for cracks or tears that can let cold air escape. If you find any, replace the gasket.
Check the seal: Open the door, insert a dollar bill partway and shut the door on the bill. Try to pull out the bill. You should feel some resistance. Repeat the test at several points around each door. If the bill slips out easily, replace the gasket.
If there is any circuit breaker, reset it.
Check for thermostat problems. It could be off or won't cool properly (too warm,). If it can't be fixed with a simple adjustment, call a professional.
Check for coil problems. The compressor can overheat due to dust buildup on condenser coils. If so, vacuum the coils.
The above are the likely problem and the solution.
Take care.
Hello,
The defrost timer is usually found behind the front grill "toe kick"
of the refrigerator. It may also be found behind a cover plate inside
the refrigerator or freezer, in the temperature control console, or
behind the refrigerator near the compressor.
To test whether the defrost timer is simply failing to
advance, locate the advance screw and turn it clockwise until
you
hear it click. This advances it to the next mode. If it was
cooling
before, it is now in defrost mode. Simply wait about 35 minutes
and check whether it has left defrost mode and has resumed
cooling
(listen for the compressor). If it does not advance, the timer
motor is probably bad and the entire timer needs to be replaced.
If
it advances as it should, then you can follow the steps below to
test
the switch electrically.
The timer is usually held in place with one
or more screws. Remove the screws and gently pull the timer
out far enough to disconnect the wiring connector. The connector
can be removed by firmly pulling and rocking it left and right.
It is
not necessary to note the position of the wires because the
connector
plug is keyed so that it can be replaced in only one way.
Take care.
Hi,
- The fan or blower has failed.
- The coil is covered over with ice and blocks the air flow.
- The fan or blower
- The timer device
- The electric heater coil
By methodically checking these parts you can isolate your problem and fix it.
There are many people that have this problem and are searching for answers as to what to do and what could be causing this problem. It seems to be weird that the freezer is working fine and the fridge side is not. Why would the coldest side be good and the warmer side not?
The answer to these questions lies in the way the freezer/fridge combo works. The freezer is where the cooling coils are located. Then air is moved over the coils and circulated through the fridge side by a small blower or fan. The problem arises when the air is not circulated for some reason.
The reasons the air is not moving is usually two reasons
The first reason is pretty simple to fix, you simply replace the air circulator and things are good again.
The second reason can be more difficult.
1. The timing device that runs the defrost cycle of the refrigerator is defective.
2. The heater coil that melts the water is shorted or not working
Usually the first thing to check is the heater coil. If there is resistance through the coil then most likely it is still good.
The timing device can be an advanced defrost control board or a mechanical timing device.
If the heater coil checks out to be good then the problem should be the timer.
For most situations, unplugging the refrigerator and allowing it to defrost on it’s own will get you going temporarily, till parts can be shipped to you. That will melt the ice and give you a few days or a couple of weeks till it ices up to the point where it will not work again.
So you can see here, the problem can usually be traced to one of three things.
Good luck.
ps-it is a fridge with the freezer on top
Hello,
yes, it means the fan is working from the fan sound you are hearing. The questions you asked has put more light to the problem.
Inspect the gasket for dirt or debris that could prevent
it from
sealing. If you find any, remove the large debris, then wash the gasket,
using a scrub brush and warm, soapy water.
Check the gasket for
cracks or tears that can let cold air escape. If
you find any, replace the gasket. If the gasket appears to be solid, go
on to step 3.
Check the seal: Open the door, insert a dollar bill
partway and shut the
door on the bill. Try to pull out the bill. You should feel some
resistance. Repeat the test at several points around each door. If the
bill slips out easily, replace the gasket.
If there is any
circuit breaker, reset it.
Check for thermostat problems. It
could be off or won't cool properly
(too warm,). If it can't be fixed with a simple adjustment,
call a professional.
Check for coil problems. The compressor can
overheat due to dust
buildup on condenser coils. If so, vacuum the coils.
The above
are the likely problem and the solution.
There is no schematic, if not, I would have given it to you. But you can check the below link, its one of our refrigerator expert's profile and I believe the information there could help to solve your problem as there are some diagrams there.
http://www.fixya.com/support/r4024657-re...
Take care