If you noticed when it lit, there is an ignitor on the right side of the burners. On the left side is a flame sensor. Look for a lone orange or white wire leading to the flame sensor. Turn the power off and clean that flame sensor with a piece of steel wool. Reapply power and see how it does.
I need your model number to be sure, but I sounds like a flame sensor. If you have a hot surface ignitor(orange glow device) then in the same area there should be a small single wire sensor that sits in the flame Remove and wire brush the end and try that.
If you have a circuit board count the fast and slow flashes after it fails 3 tiimes and this will make a code
Answers & Comments
If you noticed when it lit, there is an ignitor on the right side of the burners. On the left side is a flame sensor. Look for a lone orange or white wire leading to the flame sensor. Turn the power off and clean that flame sensor with a piece of steel wool. Reapply power and see how it does.
I need your model number to be sure, but I sounds like a flame sensor. If you have a hot surface ignitor(orange glow device) then in the same area there should be a small single wire sensor that sits in the flame Remove and wire brush the end and try that.
If you have a circuit board count the fast and slow flashes after it fails 3 tiimes and this will make a code