GW709 MACHINE SMART DRIVE LOAD 7.5
I HOPE YOU CAN HELP ... MY MACHINE WILL NOT START ON THE SPIN/RINSE CYCLE ... THE LIGHT DISPLAY IS AS FOLLOWS
1 2 3 4 5 6 7 8 OFF OFF ON ON ON ON ON OFF
WE HAVE CHECKED HOSES AND DISCHARGED PORTS
THE MACHINE SEEMS TO RUN IN THE WASH MODE BUT WILL NOT ACTUALLY SPIN IN THE RINSE/SPIN MODE ... ANY HELP WOULD BE APPRECIATED .. WE HAD A TECHNICIAN OUT APPROXIMATELY 2 MONTHS AGO WHO CHANGED THE AUTOMATED BALANCE MODULE IN THE CONTROL PANEL. MANY THANKS JENNIFER TULLY
1 2 3 4 5 6 7 8 OFF OFF ON ON ON ON ON OFF
WE HAVE CHECKED HOSES AND DISCHARGED PORTS
THE MACHINE SEEMS TO RUN IN THE WASH MODE BUT WILL NOT ACTUALLY SPIN IN THE RINSE/SPIN MODE ... ANY HELP WOULD BE APPRECIATED .. WE HAD A TECHNICIAN OUT APPROXIMATELY 2 MONTHS AGO WHO CHANGED THE AUTOMATED BALANCE MODULE IN THE CONTROL PANEL. MANY THANKS JENNIFER TULLY
Washing Machines - Fisher and Paykel - GWL11 Top Load Washer
Answers & Comments
Hi All,
I've just had a similar problem with a GW709 Phase 5, in that it would not spin. It would pump out the water and then sit there with the pump running. It would do a inner bowl check and that is all. Finally it would time out and give a beep every 5 secs or so.
No "last faults" could be identifed in the diagonist mode 3
The problem turned out to be a blocked pressure sensor pipe.
Cheers,
L300van
Hi
if it washes ok but won,t spin it canbe pump if it has not pumped all the waterout or can be lid switch,but normally they won,t wash if the lid switch is funny so i would be checking the pump side of things
cheers grantsreps