Had a blown engine and swapped out for Used Unit. Was running when switched but after install will crank but no Ignition. Lots of fuel and compression but no Spark at coils
That is a good idea. When I swap engines I always swap the sensors with it. Just because I know that the sensors off the old engine worked.That is a good idea. When I swap engines I always swap the sensors with it. Just because I know that the sensors off the old engine worked.
This model uses the direct ignition system. Is there a way to test the control unit itself.This model uses the direct ignition system. Is there a way to test the control unit itself.
Answers & Comments
The crank shaft position sensor or ignition module is bad.
Thanks, I will do some swapping with the original and give it a go.
That is a good idea. When I swap engines I always swap the sensors with it. Just because I know that the sensors off the old engine worked.
Go over the wiring again, most probably missed a ground to coil
This model uses the direct ignition system. Is there a way to test the control unit itself.