Haier XQB55-10 : water leakage from inlet hose jointer
Haier XQB55-10
problem in connectin between the water inlet hose jointer and the water tap.
we have water tap exactly as in the manual.
after fitting water inlet hose with the pipe , during water flow, water comes upward direction, i.e ., leaking
My question:
Why it is leaking?
what should i do to avoid leaking?
Washing Machines - Haier - HWD1000
Answers & Comments
Inside the connector is a flat washer and a mesh filter. one side of the mesh filter has a strip/bar across it, this filter goes into the base of the connector with the strip/bar upwards, make sure it is seated in the connector properly.
Then fit the flat washer ensuring that it is clean/undamaged and lying flat at the base of the connector, the mesh filter strip/bar has at either end a small lip, the washer goes underneath the two lips, if it is placed on top of these lips it leaks!
99% positive on this, if not buy another hose!
You must examine your machine hose to see if it is blocked. Clean out the fine nets in the hose as well as at the machine entry (inlet water entry). Clean well with a tooth brush, refit carefully. Water should be in good pressure for machine operation.