I assume you mean valve not bilge.. Unplug the connector If you use an ohm meter and measure resistance of 2 outside pins and then 2 inside pins they should be the about the same,if not replace it If it's good get the PCM looked at by a shop.
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
I assume you mean valve not bilge..
Unplug the connector
If you use an ohm meter and measure resistance of 2 outside pins and then 2 inside pins they should be the about the same,if not replace it
If it's good get the PCM looked at by a shop.