Hello ! I am from 2 weeks a new kettler marathon tx 1 tredmill. Few days ago when I want to modify the rising angle , this one is out of order. So after it I saw that on the display is not shown the angle only 2 lines in the midle.I tried to push the button up but nothing was happend.I tried to use after it the program P4 and P5 also P8. Is not possible , when i push the button for change the program it appeaps P1-P2-P3-P6-P7 and again P1...... So I don't know What is the problem? I am very angry because in this situation I can't use the treadmill because when it happend the angle was 0. I want to mention that when I bought them 2 weeks ago , it was function corectly.thank you and I wait your answer
DEAR I THINK YOUR HAND BAR KEY INCLINE STUCK YOU SEE IT AND FREE THE KEYS STUCK .IF NOT YOU MUST GUESS ELECTROSTATIC ELECTRCITY WHEN YOU RUN ON AND TOUCH HAND BAR YOU GUESS A FEW ARC THIS IS BECAUSE OF YOUR BELT IS DAMAGE AND THE ELECTRICITY DAMAGE YOUR MONITOR AND YOU MUST REPAIR IT . you can countinue contact us with smart phone on wattsapp or telegram by : +989195116738
Answers & Comments
DEAR
I THINK YOUR HAND BAR KEY INCLINE STUCK YOU SEE IT AND FREE THE KEYS STUCK .IF NOT YOU MUST GUESS ELECTROSTATIC ELECTRCITY WHEN YOU RUN ON AND TOUCH HAND BAR YOU GUESS A FEW ARC THIS IS BECAUSE OF YOUR BELT IS DAMAGE AND THE ELECTRICITY DAMAGE YOUR MONITOR AND YOU MUST REPAIR IT .
you can countinue contact us with smart phone on wattsapp or telegram by :
+989195116738