Trouble shooting I did: When I disconnected the SC Board from P2 and the A20 ribbon, I still get the 10 blink code. However I went further and tested all different boards by disconnecting them. Here is how I managed to turn the TV on without picture and did not get any blink codes. If SC Board's P2 + A20 ribbon + A32 ribbons (I don't know which board this goes to) are disconnected, then the TV turns on without picture. If I go further and disconnect the P11 and SS33 the TV still turns on. However, if I plug back any of these ribbons (A32 or A20 or both) or the P2 power to SC Board I get the 10 blink codes again. I visually inspected all parts and they all look clean and intact. Capacitors look in good shape. No burn marks or any other stains anywhere inside the TV. Which parts do I need to purchase to fix my TV. Thank you.

Photography - Panasonic - TC-P50U2 50-Inch 1080p Plasma HDTV