Hi, the belt has come off and I need to get in there to change it . do I undo the screws at the bottom and lift the whole outer cover off or what?there does`nt seem to be a back cover like the normal frontloader. Thank you. Basil
Normally there should be two screws at the bottom of the front panel. The top cover usually lifts up by depressing the spring tabs located in the gap between the top cover and the front panel to allow lifting of the front panel. These tabs are located about two inches from each end and you can use a putty knife to push back.
Push the tabs back and lift the cover up, then remove either two screws located inside the front panel or two screws on the outside at the bottom of the front panel and lift the front panel slightly to disengage. Remember to unplug unit before servicing. Hope this helps.
Answers & Comments
Normally there should be two screws at the bottom of the front panel.
The top cover usually lifts up by depressing the spring tabs located in the gap
between the top cover and the front panel to allow lifting of the front panel. These tabs
are located about two inches from each end and you can use a putty knife to push back.
Push the tabs back and lift the cover up, then remove
either two screws located inside the front panel or two screws on the outside at the
bottom of the front panel and lift the front panel slightly to disengage. Remember to
unplug unit before servicing. Hope this helps.