Homelite edger won't start
I've replaced the spark plug and have tried putting a little gas directly into the cylinder (through spark plug port) and it won't fire off once. Last time it ran, it ran really well, but only in the full choke position, Might have two problems.
What do I do and where do I start.
Thanks
Garden - Homelite - Mighty Lite Lawn Trimmer
Answers & Comments
Try this first...
Sounds like you will need to clean your carburetor.
Sometimes you can get by with priming it a few times, and letting it
run a few times like that and it will flush the gunk out of the jets,
but most of the time you will need to rebuild the carburetor.
If the mower is over a couple years old, then I also recommend that you
buy and install a new carburetor repair kit, because the diaphragm will
get hard and that will cause it to be hard to crank.
When you clean your carburetor and remove the jet screws, count the
number of turns it takes to seat the jets from their original position.
That way when you go to put the jets back in, you know how many turns
they were in/out.
Please rate me, Thanks
Good Luck, I hope this helped