Remove filler cap, lift car then from under the car remove oil pan drain plug. Allow oil to drain into an oil waste pan. Change oil filter also ..located under skid plate..use filter wrench to remove filter. Be careful as filter is full of oil ..drain in waste pan wipe filter mounting plate clean..put a thin coating of oil on new filter gasket before spinning it on to the mounting plate..hand tighten and then tighten about 3/4 more turn.. reinstall drain plug. do not over tighten or you can strip the threads. Install correct viscosity and amount of oil start engine. let run to get pressure up. shut off engine, check level with dipstick and close cap....you are done.
Answers & Comments
Remove filler cap,
lift car
then from under the car remove oil pan drain plug.
Allow oil to drain into an oil waste pan.
Change oil filter also ..located under skid plate..use filter wrench to remove filter. Be careful as filter is full of oil ..drain in waste pan
wipe filter mounting plate clean..put a thin coating of oil on new filter gasket before spinning it on to the mounting plate..hand tighten and then tighten about 3/4 more turn.. reinstall drain plug. do not over tighten or you can strip the threads. Install correct viscosity and amount of oil start engine. let run to get pressure up. shut off engine, check level with dipstick and close cap....you are done.