Setting Top of Form, Forms Tear-Off ON

(Step A)

! If you turn the platen knob when the printer is turned

on, you will cause the Top of Form to mis-align. Always

turn the printer off before turning the platen knob!

1 Turn the printer ON.

2 Park the paper.

3 With paper out of the unit, (red alarm light should be on)

press SHIFT (1) and QUIET/TOF (5) to reset the current

Top of Form.

4 Press FF/LOAD (3) to load the paper.

5 Press SEL/MENU (6) to take the printer off line.

The SEL light goes out.

6 Wait until the paper moves up to the tear position, then

press and hold TEAR (4).

The paper moves to the current Top of Form.

Keep pressing and holding TEAR.
7 Press and hold SHIFT and release TEAR.

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response

Thanks, Joe



I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309