See page 8 8 8 FIRST USE Rinse water tank before first use. Fill water tank with fresh, drinking water. insert water tank to machine. Switch machine on. Power button starts blinking red while machine is heating up for approx. 40 seconds. Afterwards power button lights steady green and machine is ready. 40 sec ON Push selection lever to the "HOT" position. Machine starts rinsing. Open locking handle and insert empty capsule holder. Close locking handle. Place jug under outlet. Push selection lever to the "COLD" position. Machine starts rinsing. After approx. 60 seconds push selection lever to the "STOP" position. Empty jug and refill water tank with fresh, drinking water. Make sure that the selection lever is in "STOP" position. Then plug the power plug into a mains power socket. After approx. 60 seconds push selection lever to the "STOP" position. Machine stops rinsing and power button blinks red for about 5 seconds. 1 4 7 2 5 8 Place drip grid on drip tray. Then insert drip tray at desired position of drip tray. Then insert drip tray at desired position of machine.
Answers & Comments
See page 8
8
8
FIRST USE
Rinse water tank before first use.
Fill water tank with fresh, drinking water. insert
water tank to machine.
Switch machine on. Power button starts
blinking red while machine is heating up for
approx. 40 seconds. Afterwards power button
lights steady green and machine is ready.
40 sec
ON
Push selection lever to the "HOT" position.
Machine starts rinsing.
Open locking handle and insert empty capsule
holder. Close locking handle.
Place jug under outlet.
Push selection lever to the "COLD" position.
Machine starts rinsing.
After approx. 60 seconds push selection lever
to the "STOP" position. Empty jug and refill
water tank with fresh, drinking water.
Make sure that the selection lever is in "STOP"
position. Then plug the power plug into a
mains power socket.
After approx. 60 seconds push selection lever
to the "STOP" position. Machine stops rinsing
and power button blinks red for about 5
seconds.
1
4
7
2
5
8
Place drip grid on drip tray. Then insert drip
tray at desired position of drip tray.
Then insert drip tray at desired position of machine.