How do I put the dishwasher into diagnostic mode?
Frigidaire 24 in. FDB126RB Built-in Dishwasher FDB126EBS2 My dishwasher has an intermittent problem. Sometimes it will start normally, run for a short period, then it will stop. I will have to go through this cycle several times before a regular cycle will run. I've inspected the float valve okay & clicks; used multimeter and checked for continuity, also appears to be fine; also checked the inlet valve for continuity; everything seems to be fine I'm wondering if there is some issue with the controller failing? Is there a diagnostic mode on this device I can get any sorta error codes? Does anyone know of any control failure bulletins on this device? Thanks for all your help.
Dishwashers - Frigidaire - 24 in. FDB126RB Built-in Dishwasher
Answers & Comments
Hello friend, thank you for your inquiry!
From the information you have provided you would like to place your Frigidaire dishwasher into a diagnostic mode. I have reviewed the dishwasher and do not show a diagnostic mode available. Based off the information you have provided you may be experiencing an issue with your timer or knob. I would suggest performing a factory reset on your dishwasher and you can do that by flipping the breaker off for at least ten minutes. Since it could be an issue with either electrical components you may need to seek guidance from a professional technician. I hope this information is helpful to you. -Matt