HOW DO I REPLACE THE FUSE ON AN OSTER BLENDER MODEL 4094
THE FUSE HAS CUP LIKE HOLDERS ATTACHED TO EACH END. HOW DO I REMOVE AND REPLACE FUSE?
Blenders - Oster - 4093-8 Osterizer Classic Blender 2-Speed Blender
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
Unplug it.... use a small plastic screw driver or even a metal one if you are careful... pry gently up on one side of the fuse... it should pop out of the holder. when it does... use your fingers to grab the end and pull up. the fuse is replaced by placing it back into the holder and pushing down until each end pops back into the holder