1.Turn off the camera. 2. Remove your battery and memory card. 3. wait at least 3-5 minutes. 4. Insert fresh battery and memory card. 5. Turn on the camera. 6. It should work now.
Most lock problems can be solved with this method. But if it will not work then please give some information about the situation. Thank you.Most lock problems can be solved with this method. But if it will not work then please give some information about the situation. Thank you.
Sometimes it is necessary to change memory card. Try with the old one first, then try without memory card and lastly try with another or with a new memory card please. These checks must be done. After that, there are some detailed checks. Meanwhile after the above checks, you should press all the buttons one by one. Because in some cases one or two buttons can be found as a pressed condition. Please control that too.Sometimes it is necessary to change memory card. Try with the old one first, then try without memory card and lastly try with another or with a new memory card please. These checks must be done. After that, there are some detailed checks. Meanwhile after the above checks, you should press all the buttons one by one. Because in some cases one or two buttons can be found as a pressed condition. Please control that too.
Answers & Comments
Hello,
There are many reasons for this.
But at least you may try this first.
1.Turn off the camera.
2. Remove your battery and memory card.
3. wait at least 3-5 minutes.
4. Insert fresh battery and memory card.
5. Turn on the camera.
6. It should work now.
This is a basic reset for your camera.
Regards.
Most lock problems can be solved with this method. But if it will not work then please give some information about the situation. Thank you.
Sometimes it is necessary to change memory card. Try with the old one first, then try without memory card and lastly try with another or with a new memory card please. These checks must be done. After that, there are some detailed checks. Meanwhile after the above checks, you should press all the buttons one by one. Because in some cases one or two buttons can be found as a pressed condition. Please control that too.