Place the steering wheel in the center (wheels straight ahead) position.
Disarm the SRS system, as outlined in the Chassis Electrical System.
Make sure the negative battery cable is disconnected.
Remove the steering wheel, as outlined in this section.
Remove the upper and lower steering column switch trim. Refer to the Turn Signal (Combination) Switch or Multi-function switch procedure for details.
Disconnect the multi-pin connector from the ignition/starter switch.
Remove the locking fluid (paint) from threaded holes of screws.
Loosen the two screws slightly, and pull ignition/starter switch out from steering lock housing in direction shown.
Remove the locking fluid (paint) from threaded holes of the screws (A). Loosen the two screws (A) slightly, then pull the ignition/starter switch out from steering lock housing in direction of the arrow
To install:
Push the ignition/starter switch into steering lock housing.
NOTE When installing the ignition/starter lock switch ensure that the ignition/starter lock switch and the lock cylinder are in the same position, e.g. "ignition on".
Tighten screws and seal securing holes with sealant D2.
Connect multi-pin connector to ignition/starter switch.
Install steering column switches, steering wheel trim and steering wheel, as outlined in this section.
Answers & Comments
This is for the requested item:
- If necessary, make sure you have the radio code.
- Place the steering wheel in the center (wheels straight ahead) position.
- Disarm the SRS system, as outlined in the Chassis Electrical System.
- Make sure the negative battery cable is disconnected.
- Remove the steering wheel, as outlined in this section.
- Remove the upper and lower steering column switch trim. Refer to the Turn Signal (Combination) Switch or Multi-function switch procedure for details.
- Disconnect the multi-pin connector from the ignition/starter switch.
- Remove the locking fluid (paint) from threaded holes of screws.
- Loosen the two screws slightly, and pull ignition/starter switch out from steering lock housing in direction shown.
- Push the ignition/starter switch into steering lock housing.
- Tighten screws and seal securing holes with sealant D2.
- Connect multi-pin connector to ignition/starter switch.
- Install steering column switches, steering wheel trim and steering wheel, as outlined in this section.
Removal & Installation
Remove the locking fluid (paint) from threaded holes of the screws (A). Loosen the two screws (A) slightly, then pull the ignition/starter switch out from steering lock housing in direction of the arrow
To install:
NOTE When installing the ignition/starter lock switch ensure that the ignition/starter lock switch and the lock cylinder are in the same position, e.g. "ignition on".