How do you re caliberate the printer for red error message display to go away and the printer to start printing the lable again. Created by anonymous. Office Equipment & Supplies - Datamax - I - I-4208 Thermal Label Printer

How do you re caliberate the printer for red error message display to go away and the printer to start printing the lable again

February 2021 1 13 Report

How do you re caliberate the printer for red error message display to go away and the printer to start printing the lable again

Office Equipment & Supplies - Datamax - I - I-4208 Thermal Label Printer

Answers & Comments

Anonymous

Hello,

If you use ms-access you must have installed the windows driver, therefore you must enable the cutter in the printer properties. Position fault is that it does not detect the label, must be press the FEED key or to calibrate, press the FEED key for 5 seconds to calibrate the sensor label.

Take care

Answers & Comments

Helpful Links

Helpful Social