RTM ,. read the shop manual first.? its all there to read 24/7. Is this car A USA CAR?
generic.
drain tank fully, or you will get a flood of fuel on YOU.
remove all hoses to tank/vents and wires, to pump rack top,.
remove filler neck hose to tank.
with a floor jack under tank, and wood protector to it, try to raise tank just a tad. (1/2?") (I have car at rear on jack stands first)
remove tank straps. now.
lower jack, done.
now out of shop manual quoted SX4 , near.
1) Relieve fuel pressure in fuel feed line according to "Fuel Pressure Relief Procedure". 2) Disconnect negative cable at battery. 3) Remove fuel filler cap. 4) Insert hose of a hand operated pump into fuel filler hose (1) and drain fuel in space "A" as shown in figure.(this car has check valve at tank inlet) Hoist vehicle, and remove clamp (2), fuel filler hose (1) and breather hose (3) from fuel filler neck. 6) Remove exhaust center pipe referring to "Exhaust Pipe and Muffler Removal and Installation in Section 1K". 7) Remove propeller shaft (For 4WD model) referring to "Propeller Shaft Assembly Removal and Installation in Section 3D". 8) Due to absence of fuel tank drain plug, drain fuel tank by pumping fuel out through fuel tank filler. Use hand operated pump device to drain fuel tank. Disconnect quick joint (fuel pipe) (1) from fuel pipes (2) referring to "Fuel Hose Disconnecting and Reconnecting". 10) Support fuel tank (1) with jack (2) and remove its mounting bolts (3) Lower fuel tank a little as to disconnect wire harness at connector (1)and ground wire (2), then remove fuel tank
Answers & Comments
RTM ,. read the shop manual first.? its all there to read 24/7.
Is this car A USA CAR?
generic.
now out of shop manual quoted SX4 , near.
1) Relieve fuel pressure in fuel feed line according to
"Fuel Pressure Relief Procedure".
2) Disconnect negative cable at battery.
3) Remove fuel filler cap.
4) Insert hose of a hand operated pump into fuel filler
hose (1) and drain fuel in space "A" as shown in
figure.(this car has check valve at tank inlet)
Hoist vehicle, and remove clamp (2), fuel filler hose
(1) and breather hose (3) from fuel filler neck.
6) Remove exhaust center pipe referring to "Exhaust
Pipe and Muffler Removal and Installation in Section
1K".
7) Remove propeller shaft (For 4WD model) referring to
"Propeller Shaft Assembly Removal and Installation
in Section 3D".
8) Due to absence of fuel tank drain plug, drain fuel
tank by pumping fuel out through fuel tank filler.
Use hand operated pump device to drain fuel tank.
Disconnect quick joint (fuel pipe) (1) from fuel pipes
(2) referring to "Fuel Hose Disconnecting and
Reconnecting".
10) Support fuel tank (1) with jack (2) and remove its
mounting bolts (3)
Lower fuel tank a little as to disconnect wire harness
at connector (1)and ground wire (2), then remove
fuel tank