How to come out of standby mode and Iconn1 Philips 42HF9442?
I have got stuck in a very awkward situation with my TV. I need urgent help with a Philips 42HF9442. Accidentally I had put the settings for Setup - Communication - Iconn1. The Remote Control and Local keyboard stopped working. Before I could do something on that , because of the settings :- ESP: Energy Saving Programmability Mode ESP and Power On: LAST STATUS,it went to standby mode . I am now stuck on the standby mode red light whenever I switch on the TV. Please help!!! Your response will be highly appreciated. Thanks and regards, Anil
Televison & Video - Philips
Answers & Comments
Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electronicshelponline.blogspot.com/
In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.
Before going further; try a hard reset first. If it does not help you, replace the main digital board. There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; visit the site linked here.