With a Phillips screwdriver loosen the two screws and remove the chain guard. With a 10mm wrench loosen the brake cable anchor and disconnect the cable. With two 8mm wrenches loosen the brake housing anchor and disconnect. (Keep the spacer and washers together.) With a 10mm wrench loosen both axle adjusters an equal amount. (roughly five turns) With two 17mm wrenches loosen the axle. Push the wheel forward in the slots to loosen the chain. Pull the wheel out. (Pay careful attention to the order the hardware is in there.) Regards, Tomy
sorry i ment much sorry i ment much
Your very welcome. Your very welcome.
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
sorry i ment much
Your very welcome.