The unit will go into protection mode when there is a short in the speaker wires or the unit was overloaded. Verify that none of the speaker wire connections are loose at the back of the unit or at each speaker. And verify that none of the wires are making contact with each other.
If it is, then remove the speaker wires and connect them again properly. After disconnection get the speaker wires, unplug the unit for 10 to 15 minutes or more. This will make the overload protection back to normal.
Try this and let me know what happens. I hope this would solve the issue
Answers & Comments
Hi,
The unit will go into protection mode when there is a short in the speaker wires or the unit was overloaded. Verify that none of the speaker wire connections are loose at the back of the unit or at each speaker. And verify that none of the wires are making contact with each other.
If it is, then remove the speaker wires and connect them again properly. After disconnection get the speaker wires, unplug the unit for 10 to 15 minutes or more. This will make the overload protection back to normal.
Try this and let me know what happens. I hope this would solve the issue
Thanks