One side of the switch has Brass screws, and the other has nickle screws. there is usually a small brass bridge between the upper, and lower switch screws on the brass screw side. if you are feeding both from a common power source leave the little brass bridge in place, and screw on of the screws in all the way. Put the energised wire under the other brass screw. Bare copper wire goes to the green screw. The power will be transferred to the nickle screws through the corresponding switch. put the wire to the fan on one, and the light on the other. Presto.
Answers & Comments
One side of the switch has Brass screws, and the other has nickle screws. there is usually a small brass bridge between the upper, and lower switch screws on the brass screw side. if you are feeding both from a common power source leave the little brass bridge in place, and screw on of the screws in all the way. Put the energised wire under the other brass screw. Bare copper wire goes to the green screw. The power will be transferred to the nickle screws through the corresponding switch. put the wire to the fan on one, and the light on the other. Presto.