I am trying to get an open NAT for halo reach but I have made a static IP and tried forwarding ports and such and restarting the router and nothing seems to be working. What do I need to do?
Was it working befor you used a static IP in the device? check the firewall rules, you could try seting a dynamic IP on the device than looke for it in the DHCP table of the router to open the correct ports to the correct IP (temporarely) to see if *** works, than do the same with a static IP (STEP BY STEP) there is no reason for it not working with static IP versus dynamic IP, you could also try a DMZ on the IP's device (temporary) to make sure it's not the firewall
Answers & Comments
Was it working befor you used a static IP in the device? check the firewall rules, you could try seting a dynamic IP on the device than looke for it in the DHCP table of the router to open the correct ports to the correct IP (temporarely) to see if *** works, than do the same with a static IP (STEP BY STEP) there is no reason for it not working with static IP versus dynamic IP, you could also try a DMZ on the IP's device (temporary) to make sure it's not the firewall
Good luck!