First type in "1" on both the Sets when you are prompted for the pass code, sometimes this helps. Well, If you don't remember the passkey/passcode, then it's best for you to resync (re-pair them again) and assign another code/passcode. You can do this by doing a search from one of the Unit and assigning the code again. Note: pass code can be any number even only one number will do. So i would suggest you not to used long and many numbers. Even if you set "0" that's fine. Awaiting your action.:-) Good luck. Thank you for using FixYa.
Answers & Comments
First type in "1" on both the Sets when you are prompted for the pass code, sometimes this helps. Well, If you don't remember the passkey/passcode, then it's best for you to resync (re-pair them again) and assign another code/passcode. You can do this by doing a search from one of the Unit and assigning the code again. Note: pass code can be any number even only one number will do. So i would suggest you not to used long and many numbers. Even if you set "0" that's fine. Awaiting your action.:-) Good luck. Thank you for using FixYa.