I bought a Dremel Advantage 961 flex shaft quite some time ago and just tried to use it yesterday for the first time. I have installed the "Drive Nut" on the Advantage unit and then installed the flex shaft. It seemed to go together OK but the burr on the hand unit won't turn when you turn the unit on. It seems like the drive cable might not be long enough or it may be going inti the shaft of the drive unit too far. I can't find a manual on the flex unit to see if I might be missing something. Any suggestions you could prove would be greatly appreciated. Thanks. Jerry Hosier
Sell it to me... im on my third one and cant find a new shaft...... i make mushroome sticks.....not happy at allllll.... dremel needs to make them again now.............im out of luck.. model 961 hasent been produced in10 years!!!!!!!!!!******.. still cant finf replacment parts.........t-bone..
Answers & Comments
Sell it to me... im on my third one and cant find a new shaft......
i make mushroome sticks.....not happy at allllll....
dremel needs to make them again now.............im out of luck..
model 961 hasent been produced in10 years!!!!!!!!!!******..
still cant finf replacment parts.........t-bone..