There is no relation of battery to soft top.The soft top gets power from battery.The power is by the switch.The battery gives power to switch and switch gives power to soft top.--------- NOTE:------------ If the top does not operate or stops during theraising or lowering procedure, start the engine and continue operation.1. Make sure the rear cargo compartment divider isunfolded and secured in the vertical position. A slowaudible information signal will be heard and the convert-ible top switch lamp will flash slowly if the cargocompartment divider is not in the vertical position. If thedivider is in its stowed position, first unfold the panelstowards the rear of the vehicle. Pull up on the verticalpanel using the center cutout shown, and hook the pinsat the top into the brackets mounted to the cargo com-partment trim on each side near the forward edge of thedecklid opening. The pins must be hooked in thesebrackets in order for the top to operate.------- 2. Make sure the decklid is closed.---- 3. Turn the ignition key to the ON/RUN position.------- 4. Unlock the top from the windshield header by push-ing the latch handle release button, pulling the latchhandle down and turning it clockwise just over onequarter turn.----------- ---------------- Also there is manual for your car, in that there is more details regarding operating the top manually .see if its getting open , close manually :--- Click this link below and see page number 54:--- http://www.scribd.com/doc/45713773/2005-Crossfire-SRT6-Owner-s-Manual#outer_page_52 ---------- If it operated manually but not be the switch, then problem is switch or motor.it has to be inspected.------ This will help.Thanks.Helpmech.
Answers & Comments
There is no relation of battery to soft top.The soft top gets power from battery.The power is by the switch.The battery gives power to switch and switch gives power to soft top.--------- NOTE:------------ If the top does not operate or stops during theraising or lowering procedure, start the engine and continue operation.1. Make sure the rear cargo compartment divider isunfolded and secured in the vertical position. A slowaudible information signal will be heard and the convert-ible top switch lamp will flash slowly if the cargocompartment divider is not in the vertical position. If thedivider is in its stowed position, first unfold the panelstowards the rear of the vehicle. Pull up on the verticalpanel using the center cutout shown, and hook the pinsat the top into the brackets mounted to the cargo com-partment trim on each side near the forward edge of thedecklid opening. The pins must be hooked in thesebrackets in order for the top to operate.------- 2. Make sure the decklid is closed.---- 3. Turn the ignition key to the ON/RUN position.------- 4. Unlock the top from the windshield header by push-ing the latch handle release button, pulling the latchhandle down and turning it clockwise just over onequarter turn.----------- ---------------- Also there is manual for your car, in that there is more details regarding operating the top manually .see if its getting open , close manually :--- Click this link below and see page number 54:--- http://www.scribd.com/doc/45713773/2005-Crossfire-SRT6-Owner-s-Manual#outer_page_52 ---------- If it operated manually but not be the switch, then problem is switch or motor.it has to be inspected.------ This will help.Thanks.Helpmech.