I can't connect my Futaba T7c transmitter to FMS flight simulator
I have a new Futaba T7c transmitter and purchased a new FMS Simulator USB Line Cable Adapter For Esky JR or Futaba.
Cable Details from Vender:
Suited for JR, Futaba,& Esky .... transmitters
Support: FMS Software
Support: USB HID1.1
Compatible: Windows 98/2000 SE. NT. XP
Input signal: PPM
this is what i received:
USB cable for Transmitter with 2.5mm Male connector *1
Adaptor transfor 2.5mm Female to esky connector *1
Adaptor transfor 2.5mm Female to Futaba connector *2
FMS software CD include 270 models
My problem:
when i plug in my cable on the back side to the transmitter via a 6 pin square plug and connect the USB connector end to my lap top running XP, the LED light in the USB device flashes red constantly. i have no control or connectivity to the FMS simulator program through my transmitter. i can control the program through my keyboard.
why does the USB devise flash red and how do i get it to work from my transmitter?
Toys - Futaba - 7c Computer Radio Air R617fs S3152 Servo
Answers & Comments
Hi there,
Well, first of all I suggest you to check the 6 pin plug, check out the pins are proper....
Second option is - uninstall the software completely from your laptop and install it again.
Third option is discharge your radio to 0 (nil). Turn it on until it gets discharge. Do not charge it again shortly give a 24 hour break...
Than try connecting again.......
Good Luck!!
Thanks