I get 0 pressure on the suction line and about 160 on the high
After I replaced the compressor on the condenser. Also replced the dryers on both lines.
I get 0 suction on the suction line and about 160. I have flushed the lines and I don't see any restriction, nitro flows well.
What could of be?
I get 0 suction on the suction line and about 160. I have flushed the lines and I don't see any restriction, nitro flows well.
What could of be?
Heating & Cooling - Ruud - UAKA060 Air Conditioner
Answers & Comments
Bad thermostaic expansion valve inside.
Another possibility is ice clogging the jet, if you have moisture in the system. Did you purge with a vacuum pump? Try heating the jet to melt the ice? If that makes it flow, then you need to run the vacuum pump until it is totally dried out.