I had a lift motor go out on my 9500hr treadmill, I changed the lift motor. Now when i try to get the treadmill to inclin it only does it in the manual mode. when i try to get it to incline through the auto mode it will not and it when i am in the manual mode it will only incline to 9.0. if anyone has any helpp let me know
Exercise & Fitness - Life Fitness - 9500HR Next Generation Remanufactured Treadmill
Answers & Comments
Replacing that motor is a very difficult process to get correct. It’s not just a swap out. You should absolutely have a professional do it.
1) Try to measure the if there are 110Vca in the terminal in forward or reverse.
2) Try to measure the ESR from Capacitor and replace it.
3) If you system as LIMIT Switch , test for continuity with DMM for faulty and replace, or some wires loose or disconnect.
4) If you system are Relais see if the relais for UP and down, and working most of them has LED that will be LIT indicating working or NOT
5) If NOT voltage Vca are NOT, coming from The Controller Board Motor, REPLACE IT,
Control board motor has 3 power supply: 1) Console board 2)Elevation Motor 3) Main Motor.
Some IGTBs are Defective.
Blessing.
[email protected]
cell+whatsAPP:+50588611441
LED Blink Patterns on the Control Board Treadmill