I have a 1997 Sebring convertable that the check engine light is on. Our local Autozone parts dealer has a tester that says it needs the 1st o2 sensor. I can replace this part but I can't find it. Can you send a diagram showing where this sensor is and how to get to it (Underneath or above). Please note that I have the convertible model which is not the same a sebring
Cars & Trucks - Chrysler - Sebring
Answers & Comments
Remove from under the vehicle. See image for location below;
Raise and safely support the vehicle.
Unplug the upstream oxygen sensor connector.
Remove the sensor using a suitable oxygen sensor crow's foot wrench. After removing the sensor, the exhaust manifold must be cleaned with an 18mm x 1.5 + 6E tap.
Hello, I can help you with this but I need to know if you have the 4 cylinder engine or the 6 cylinder engine.
Hello again and thank you for that information. Yours is under the hood, under you exhaust manifold and mounted directly in the exhaust pipe. Please note, even though you must be careful to not get burned, it's best to remove the old one with the engine at normal operating temperature.