I have a 99 mitsubishi galant and attemted to replace hub. did all the fun brake removal had to beat rotor off ( stripped the little holes on your rotor that are threaded that you can thread little bolts into and pulls rotor) . then to get hub nut off was alot W D and non stop impacting untill impact was hot. finally got it off and proceeded to pound axle out wd and tourch (map gas) and sledge well it was a long night but finally broke it loose and now have to replace axle mushroomed the *u*kout of it? so what is the best way to remove axle with out destroying it that the axle spline are rusted together inside the hub assembely
Spray rust lubricant and let it set for a while you can also heat it up and then spray so the lubricant can penetrate into the gap. put the axle nut on the axle to protect it and hit on it since you are going to replace the axle so why care if it's bad.
Answers & Comments
Spray rust lubricant and let it set for a while
you can also heat it up and then spray so the lubricant can penetrate into the gap.
put the axle nut on the axle to protect it and hit on it
since you are going to replace the axle so why care if it's bad.