I have a bauknecht dishwasher....I had a power cut now an alarm is going off in the machine How do I turn it off and get the dishwasher working agaian?
Thanks for using FixYa. Please switch off the Dishwasher and disconnect the power supply from and to the Dishwasher from the mains and the power socket and re connect them after five minutes and the issue will get resolved. If still the issue persists then you’ll need to check the following---
1. Fuse (blown or tripped). 2. 120 VAC supply wiring connection faulty. Repair or replace wire fasteners at dishwasher junction box. 3. Electronic control board faulty. 4. Motor (inoperative, check resistances). 5. Door switch (open contacts). 6. Door latch not making contact with door switch. 7. Touch pad circuit defective.
Please do accept the solution if the issue is resolved or else revert for further assistance.
Hi In order to disable the warning you need to hold the power button down and the delay start button down at the same time, when it’s done correctly you should be able to choose between a 1 and a zero. Please change the temperature from 151 to 161 by doing the same thing except you hold the button to the left of cancel drain. Again you should see a 0 or a 1. Do you have a cancel drain button this not actual button you have to press 2 buttons to cancel drain? Let us know if you need further clarification. Thanks for contacting fixya.com
Answers & Comments
Hi
Thanks for using FixYa. Please switch off the Dishwasher and disconnect the power supply from and to the Dishwasher from the mains and the power socket and re connect them after five minutes and the issue will get resolved. If still the issue persists then you’ll need to check the following---
1. Fuse (blown or tripped).
2. 120 VAC supply wiring connection faulty. Repair or replace wire fasteners at dishwasher junction box.
3. Electronic control board faulty.
4. Motor (inoperative, check resistances).
5. Door switch (open contacts).
6. Door latch not making contact with door switch.
7. Touch pad circuit defective.
Please do accept the solution if the issue is resolved or else revert for further assistance.
Thanks
Rylee
Hi
In order to disable the warning you need to hold the power button down and the delay start button down at the same time, when it’s done correctly you should be able to choose between a 1 and a zero. Please change the temperature from 151 to 161 by doing the same thing except you hold the button to the left of cancel drain. Again you should see a 0 or a 1. Do you have a cancel drain button this not actual button you have to press 2 buttons to cancel drain? Let us know if you need further clarification.
Thanks for contacting fixya.com