I have a Belkin F5D7230au4 wireless router and have just recently changed broadband providers. I have been into the router configuration page to change settings, but can't find where to change some of them (such as ADSLmode = G.dmt , v=, pi=) So I can't connect. Any ideas if this is possible, or do I need a new router?
If you go to configure like you are in ,, then go to advanced now look down the list and ensure at everything is enabled very importamt this is the section that you are talking about too also check the regions a and g i had to resert mine to around the 165 on a and 1 thru 11 on g ok also make sure everything else is enabled it the setup of the router this will help get you to the connecvtion easier ok best regards mike
Answers & Comments
If you go to configure like you are in ,, then go to advanced now look down the list and ensure at everything is enabled very importamt this is the section that you are talking about too also check the regions a and g i had to resert mine to around the 165 on a and 1 thru 11 on g ok also make sure everything else is enabled it the setup of the router this will help get you to the connecvtion easier ok best regards mike