I have a Dremel model 395T6 (F013 0395 04). The other day I was using it to cut plastic. It worked fine and was turned off during operation. When turned back on for the same operation there was no sign of power. I confirmed the power souce to be ok. I examined both brushes and they both looked fine with no chips and substantial material remaining. I suspect the switch assembly. What do you recommend. Is there any volt meeter tests to apply to the switch?
Well, yes you can measure the switch, look for continuity. I suspect something else is wrong, some models had armature issues. Measure the coils and armature for continuity.
Answers & Comments
Well, yes you can measure the switch, look for continuity. I suspect something else is wrong, some models had armature issues. Measure the coils and armature for continuity.