I have a GLEO2152ESO that keeps flashing E68 and beeping. I've tried unplugging it for several hours, holding start and cancel key at the same time, but it won't stop. I do not have the manual. Please advise
This is a common fault on these dryers. It means there is a stuck key on the control panel.
Cause: Push button held too long or wedged in the control panel. Solution: Press buttons lightly and release. Disengage button. If it cannot be released manually - the panel itself must be replaced.
Answers & Comments
GLEQ2152ESO
This is a common fault on these dryers.
It means there is a stuck key on the control panel.
Cause:
Push button held too long or wedged in the control panel.
Solution:
Press buttons lightly and release.
Disengage button.
If it cannot be released manually - the panel itself must be replaced.
CLICK HERE to see it.
Thanks!
Check continuity between the 2 healing coil element terminals = 45k +/- ohms (meter on 1k setting).
should read about 12 ohms.