I have a Husqvarna HU625HWT high wheel trimmer. Will not start. I do have fresh fuel in it. It will run on starting fluid. Just 2nd season with about 6 hours on it
Float seems to work. When I pulled the plug on the bottom there was fuel there. Fuel flows from the tank with out issue.
If you have a carb with a bowl, it may have a center screw that is where the gas gets pulled up into the engine. Check the bottom inside edge of that screw. There should be a tiny hole that lets the gas up into the engine. Take a wire and clean it out and make sure it is open. Old gas can form varnish and that can plug the hole.
Answers & Comments
If you have a carb with a bowl, it may have a center screw that is where the gas gets pulled up into the engine. Check the bottom inside edge of that screw. There should be a tiny hole that lets the gas up into the engine. Take a wire and clean it out and make sure it is open. Old gas can form varnish and that can plug the hole.