I have a Kenmore elite washer he3t model 110.4674 and the error code F35 keeps coming up. We did clear out the bottom drain pump, which had a lot of debris including toys, socks...etc. How can I clear the memory of the control panel?? I keep getting the SUD and then the F35 code. We also checked if the steamer sensor is working and I get a YES for that...what is going on?? do I need to install a new water level switch??
Washing Machines - Kenmore - Elite - Elite HE5t Washer
Answers & Comments
F35 is a water level error.
The water level switch (pressure switch) has malfunctioned.
If you remove the top panel, three screws in the back, you will have access to the pressure switch.
With the tub empty, remove the vinyl hose from the switch and blow backwards through the hose to clear any restrictions.
If the fault codes return after doing this, you will likely need to replace the pressure switch.
Also - please be sure to use He soap.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.%^##
As a last resort before replacing the switch, remove ii and drop it on a concrete floor a couple of times. Worked for me -- nothing to lose!
I have the same problem with same washer. Now, When I remove the vinyl hose from the switch and blow backwards through the hose to clear any restrictions, I find I am blowing into water, I can hear it bubbling, is that what's expected?