I have a kenwood ddx 6029 and bt 200 and cannot pair a bluetooth device. It keeps saying the pin code ("0000") is incorrect. Please help me ,how i reset bt 200 bluetooth code pair?
I am assuming you are trying to pair iSound BT200. See Page 6&8 of the ISOUND BT 200 User Manual
During the first time set-up, you must hold the power/phone button down until you hear a voice say "Power on" then followed by "Ready for pairing" in order to sync your device to Bluetooth. After the initial pairing, you can let go of the power/phone button after you hear "Power on".
When a user is connected and the BT-200 is o , press ff and hold for at least 5 seconds to unpair on Bluetooth (allow another user to connect)
Also check the Kenwood DDX616 Instruction Manual Bluetooth Unit Connection Bluetooth...
Answers & Comments
I am assuming you are trying to pair iSound BT200.
See Page 6&8 of the ISOUND BT 200 User Manual
During the first time set-up, you must hold the
power/phone button down until you hear a voice say
"Power on" then followed by "Ready for pairing" in order
to sync your device to Bluetooth. After the initial pairing,
you can let go of the power/phone button after you hear
"Power on".
When a user is connected and the BT-200 is o , press ff
and hold for at least 5 seconds to unpair on Bluetooth
(allow another user to connect)
Also check the
Kenwood DDX616 Instruction Manual Bluetooth Unit Connection Bluetooth...
Kenwood DDX6019 Service Manual