Report "I have a Kenwood EW7307K, made by Delonghi, oil radiator heater. It is similar looking to the Delonghi EW0507. I spilled a small amount of juice on the top of the front cover and a couple drops dripped inside. The heater was off and unplugged at the time of the spill. I took the cover off, and started pulling off the connected wires and cleaning them. Of course I did this without noting which wires go where. They are all clean now, but I can't remember where they each attach. There is a long single black wire, a long single red wire, a long single white wire, a double white wire with a small white wire coming off, and a double black wire with a small black wire coming off. Where do I attach them to on the inside of the cover? I think the unit will work fine once I get the wires all connected again. A picture of the inside of one of a Delonghi oil heater or a wiring diagram or schematic would be very helpful. I'd appreciate any help, pictures, schematics, diagrams, explantions of where each wire attaches etc. Thanks so much"