I have a Lanzar HTG2600D amp, Iv hooked up systems for years so its not the obvious. The green light is on, everything it hooked up, the fan is running but there is no sound. I pulled the base cover off and check continuity at the RCAs and the speaker terminals and they are all good. what else could it be? or is there a common problem with this amp that I should know about?
Car Audio & Video - Lanzar - HTG2600D Car Audio Amplifier
Did you run direct to the speakers or to the rear of the radio to split factory wiring. Check to make sure that you are connected to the correct side of the wiring behind the radio. If that is correct, then check the input of the amp. Try a different source and see if you get signal. Make sure your wiring is not crimped.
I use my ipod and hook it to an 1/8" x RCA splitter and plug direct in the amp. try to isolate the amp as much as possible. 1 speaker to outputs and 1 source you know works. Then test from there.
Answers & Comments
Did you run direct to the speakers or to the rear of the radio to split factory wiring. Check to make sure that you are connected to the correct side of the wiring behind the radio. If that is correct, then check the input of the amp. Try a different source and see if you get signal. Make sure your wiring is not crimped.
I use my ipod and hook it to an 1/8" x RCA splitter and plug direct in the amp. try to isolate the amp as much as possible. 1 speaker to outputs and 1 source you know works. Then test from there.