You probably have a fault on the stand by power board. this normally requires soldering and maybe some componet changes. This is not a job for the unskilled. best carried out by a service engineer(shock hazard) there is a service kit for this available from tvs-services.com 012453925
Answers & Comments
You probably have a fault on the stand by power board.
this normally requires soldering and maybe some componet changes. This is not a job for the unskilled. best carried out by a service engineer(shock hazard)
there is a service kit for this available from tvs-services.com 012453925
Thomson 32lb130s5 no power only on standby mode