I have a Maytag Neptune electric dryer. I put it in storage and moved. When I got to my new house I had to change the plug to a 4 prong as the receptacle is different. I changed it as instructions showed and now dryer acts like theres no power. Recepticle shows appropriate voltage, but panel will not come on. Please help!!!
Dryers - Maytag
Answers & Comments
4-WIRE SYSTEM CONNECTIONS
Remove the ground strap screw from the terminal block support. Fold the ground strap over so both ends of the ground strap will be attached to the center terminal block post.
Connect the neutral (white) conductor of the cord to the center (silver) post of the terminal block. Connect the grounding (green) wire of the cord to the terminal block support using the ground strap screw.
Connect the red and black wires of the cord to the outer posts of the terminal block.
Be sure the terminal block nuts are on tight. Secure the power cord in position. Tighten the strain relief screw(s) in order to clamp the strain relief to the cord. Replace the terminal block cover.
https://www.manualslib.com/manual/809274/Maytag-Neptune.html?page=8#manual