I have A msre 206 and when i swipe a card i do not get any information on the program, the db9 and usb are connected correctly and the port opens
Televison & Video - Unitech - MSR 206-33 (msr206-33) Magnetic Card Reader
Copyright © 2024 QA.XPDF.PUB - All rights reserved.
Answers & Comments
Make sure the dip switches on the underside are set properly; I've also provided a link to the user manual...which has a list of command funtions you might try.
HTH, Mike...
http://www.ylk-ic.com/MSRE206%20User%20Manual.pdf
At this point your're going to have to read the owners manual via the link I provided you. I believe that will tell you more than we could accomplish here.
Follow the format outlined in the owners manual...look at the setting for switch one (SW1) and so on...the settings in manual are factory defaults - start from there.
Mike...
As long as your computer sees it, look in "My computer" to see that it is recognized. if it is not there the USB cable may have an open in it
Hi norman_d90,
What program are you interfacing this card swipe with. To test to see if the thing works at all, You can go to Start Run, and type in CMD.
When you get to the dos prompt, swipe a already encoded card, like a credit card, and it should show up on the dos screen, if not, then it's not set correctly.
Let me know, I've spent years with these things.
Mark
Have you gotten this to work yet.?
On the program you are using, can you confirm if it can see the card reader?
Also, kindle give information on the operating system you are using.
Thank you.