I have a rockford fosgate p250.2 amp hooked up to two 12' subs but the amp is not powering on... instead the protect light is on and im not sure if its because its so cold outside... please help and thank you for your time!
Car Audio & Video - Rockford Fosgate - Punch P2502 Car Audio Amplifier
Remove the load from the amplifier (subs) and the RCAs Retry. If the light stays on, there are internal problems with the amplifier, and it needs to be serviced. If the amplifier works normally, attach the RCA's and power on again. If it remains on, connect one sub, and then the other. Your amplifier is a 2 channel amplifier rated at 60 Watt - 4 Ohm - 2 channel(s) 125 Watt - 2 Ohm - 2 channel(s) 250 Watt - 4 Ohm - 1 channel(s) Your amplifier is not rated for a 2 ohm mono load. If you have Single voicecoil subs wired in parallel, you have a 2 ohm mono load - your amplifier will eventually fail.
Answers & Comments
Remove the load from the amplifier (subs) and the RCAs
Retry.
If the light stays on, there are internal problems with the amplifier, and it needs to be serviced.
If the amplifier works normally, attach the RCA's and power on again.
If it remains on, connect one sub, and then the other.
Your amplifier is a 2 channel amplifier rated at
60 Watt - 4 Ohm - 2 channel(s)
125 Watt - 2 Ohm - 2 channel(s)
250 Watt - 4 Ohm - 1 channel(s)
Your amplifier is not rated for a 2 ohm mono load.
If you have Single voicecoil subs wired in parallel, you have a 2 ohm mono load - your amplifier will eventually fail.