I have a Toro Zero Turn 50" mower with a Kohler 16HP engine. My PTO switch melted
While mowing, the blades stopped turning. I used my electrical tester to check the circuits and determined that the PTO swith contacts weren't working properly. The switch is DPDT so I move the wires to the other switch. The PTO came on but quit again after a half hour or less. When I pulled the push/pull knob on the switch it came out of the mecanism. The plastic end was melted. I replace the switch and the same thing happened. I don't know if it is the voltage regulatro or the clutch. Any suggestions?
Garden - Toro
Answers & Comments
Pull the wires of of the pto in case it is shorted check charge at battery tomake sure wires havnt rubbed through