I have a used poulan 2450 saw on which the oiler went out. Purchased a new one, instructions pretty brief. Included was a worm gear tool and it suggests it has to be used to adjust the worm gear. Since I have no manual for this saw I am not sure what this is all about. Anyone know how to properly adjust this worm gear on this type saw
The manufacturer's Illustrated Parts List can be found here: http://www.ordertree.com/modelinfo/PWE/2450-Gas-Saw-Type-1/75.2450-Gas-Saw-Type-1.1.59.1.html Drawing "Handle, Chassis & Bar Assembly Type 1-4" There are no better illustrations of this detail. HTH Lou
Answers & Comments
The manufacturer's Illustrated Parts List can be found here:
http://www.ordertree.com/modelinfo/PWE/2450-Gas-Saw-Type-1/75.2450-Gas-Saw-Type-1.1.59.1.html
Drawing "Handle, Chassis & Bar Assembly Type 1-4"
There are no better illustrations of this detail. HTH
Lou