I have a WBSR3140G and it sounds like its working when its the spin cycle but it is not spinning at all? what could be the problem. The water is coming out and draining ok but it is not spinning
Washing Machines - General Electric - WBSR3140GWW Top Load Washer
Answers & Comments
Have you checked the belts to make sure they have not broken ?
GE washer belt, remove power, remove back panel. If the belt is broke or loose follow the below steps.
The back panel maybe held on with screws or something simular.
On the left side is the motor, clutch, pump and belt. The pump is driven by a coupler clamped to the pump and clutch assembly. Loosen one of these clamps enough to move the coupler away so the old belt can be slipped past the coupler and also to facilitate the new belt to be installed. The belt runs in a pulley built into the top of the clutch assembly and can be "run" onto the transmission pulley very easily. To adjust the belt tension, pull out the washer, tilt it back against the wall......there are 3 nuts and bolts holding the motor assembly to the bottom frame, loosen these nuts, the holes on the motor bracket are oval shaped so the motor assembly can be moved back and forth. You can move motor to tighten or loosen the belt, just make the belt fairly snug and don't over tighten it.